Mescit Mah. Demokrasi Cad. Birmes Sanayi Sitesi B2 Blok No: 26 - Tuzla/İstanbul
tren

GENERAL INFO ON OPERATING RUG WRINGER CENTRIFUGES

Operating Rug wringer centrifuges are very simple, basicly wet rugs are rolled and placed into the Centrifuge’s inner drum and run through aproximately 4-6  minutes. Then Rugs required to be hanged for drying for 5 to 35 hours  (depending on whether conditions ) before its ready for delivering . These are industrial machines therefore they must be operated in a carefull manner by trained adults.

Rug wringer centrifuges must only be used for the purpose of drying rugs. manufacturers do not accept any responsibility of the potential risks of serious injury or Death caused by misfunction.

One of the most  important thing to watch out for is the rug rolling direction ,rugs must be rolled  accourding to the direction marked on the lid of the centrifuge. Sometimes due to different phase configuration in your shop, motor might turn the inner drum in wrong direction , please run it for first time without a Rug inside and make sure motor turns the way as shown with an arrow on it..Please do not run it with the door open , and wait untill motor completely stops before you open the door.

Rug wringer centrifuges are proven to be very safe on most rugs . Except for rubber back,leather or both side glued rugs.  Since these are industrial machines, their life time depends mainly on the operator. The most important thing is the grounding,All of the wringer centrifuges come with a grounding line. For your own safety Please make sure the grounding is done properly by a qualified technician before you run the machine. Please make sure your electrical supply is 3 phase and has minimum of  62 amps , as the motor will need 52 amps minimum to start then it will reduce to around  24 amps.. Most of the electrical motors on the wringers happen to work best with a star triangle connection type…

if you happen to wring rug that are much shorter than the size of the inner drum ,please make sure you place them evenly  balanced in the drum ,do not push all the way to the end or leave it front, try to place it in the middle.

Regarding basic maintanence, Its pretty much easy to keep your centrifuge in good condition just by checking couple of things every  one a month  Both Bearings at the cap and in the back must be lubricated using a grease pump once a month depending on usage . Belts must be checked regulary and tinghted  as needed.

 

You can call us for more information about our products and services: